Installing and removing the accessible 5
drive (Ultra Slim, top drive bay)
The following instructions apply only to the installation and removal of an
accessible drive in Ultra Slim format, in the top drive bay.
Installing an accessible drive
► Remove the screws (1).
► Push the drive carrier a few centimetres out of the casing in the direction of the arrow (2).
► Pull the drive carrier completely out of the casing in the direction of the arrow (3).
Do not dispose of the cover of the Ultra Slim drive bay. For cooling and
protection against fire you must refit the cover if you remove the drive again
later (see
► Remove the cover of the Ultra Slim drive bay.
Fujitsu
"Removing an accessible drive", Page
1
2
3
41).
System expansions
/
inch
1
4
35