Installing And Removing An Accessible 5 1/4-Inch Drive - Fujitsu Esprimo C series Operating Manual

Installing the drive cage
Drive cage
► Open the casing (see
1

Installing and removing an accessible 5 1/4-inch drive

Removing an accessible 5 1/4-inch slim drive
► Open the casing (see
► Remove the drive cage (see
1
1
2
► Close the casing (see
A26361-K1002-Z220-1-7619, edition 2
"Opening the casing", Page
2
"Opening the casing", Page
"Removing the drive cage", Page
1
1
"Closing the casing", Page
29).
► Push the drive cage at an angle into
the casing mounts (1).
► If a drive is present, connect the connector
of the data and power supply cables (2).
► Close the drive cage.
► Close the casing (see
casing", Page 30).
29).
34).
► Remove the screws from the drive cage (1).
► Take the drive out of the drive cage (2).
► Install the drive cage again (see
the drive cage", Page
► If you do not want to install a new drive, you
must refit the plastic drive cover again (see
"Installing the plastic drive cover", Page
30).
System expansions
"Closing the
"Installing
35).
34).
35