Spanning Tree Commands; Config Stp - D-Link DGS-3100 Series Cli Manual

The Spanning Tree commands in the Co
parameters) in the following table.
Command

config stp

config stp ports
config stp version
enable stp
disable stp
show stp
show stp ports
show stp instance_id
show stp mst_config_id
config stp instance_id
config stp priority
config stp
mst_config_id
config stp mst_ports
Each command is listed i n detail, as follows:
config stp
Purpose
Syntax
Description
Parameters
mmand
Parameter
{maxa ge <value 6-40> | maxhops <value 1-20> | hellotime <value 1-10> |
forwar ddelay <value 4-30>| fbpdu [enable | disable]}
<portl ist> {externalcost [auto | <value 1-200000000>] | edge [true | false] | p
[true | false | auto ] | state [enable | disable]}
[mstp | rstp | stp]
<portlist>}
<value 0-15>}
<value 1-15> [add_vlan | remove_vlan] <vidlist>
<value 0-61440> instance_id <value 0-15>
{revision_level <int 0-65535> | name <string>}
<portlist> in stance_id <value 0-15> {internalCost [auto | value 1-2
priority <value 0-240>}
To setup STP, RSTP and MSTP on the Switch.
co nfig stp {maxage <value 6-40> | maxhops <value 1-20> |
hellotime <value 1-10> | forwarddelay <value 4-30>| fbpdu
[enable | disable]}
The c onfig stp command configures the Spanning Tree Protocol
(STP) for the entire switch. All commands here will be implemented
for the STP version that is currently set on the Sw
maxage <value 6-40> − This value ma
information does not endlessly circulate throug
the network, preventing the effective propagation of the new
information. Set by the Root Bridge, thi
that the Switch has spanning tree configuration values consistent
with other devices on the bridged LAN. If the value ages out and a
BPDU has s till not been received from the Root Bridge, the Switch
S
PANNING
Line Interface (CLI) are listed (along with the appropriate
59
T C
REE OMMANDS
00000000] |
itch.
y be set to ensure that old
h redundant paths in
s value will aid in determining
9
2p