Config Serial_Port; Enable Clipaging - D-Link DGS-3100 Series Cli Manual

config serial_port

Purpose
Syntax
Description
Parameters
Restrictions
Example usa ge:
To co nfigure th

enable clipaging

Purpose
Syntax
Description
Baud Rate
D ata Bits
Parity Bits
S top Bits
Auto-Logou t
DGS3100#
To configure the serial port.
config serial_port {baud_rate [9600 | 19200 | 38400] auto_logout
[never | 2_minutes | 5_minutes| 10_minutes |
The show serial_port command configures the serial port's baud
rate and auto logout settings.
baud rate [9600 | 19200 | 38400]
communicate with the management host.
auto_logout - The amount of time the Switch's serial port can be idle
before automatically logging out. The possible v
never − There is no time limit on the length of
be open with no us
2_minutes − The console will log out the current user if there is no
use r input for 2 minutes.
5_minutes − The console will log out the current user if there is no
us er input for 5 minutes.
10_minutes − The console will log out the current user if there is no
user input for 10 minutes.
15_minutes − The console will log out the current user if there is no
user input for 15 minutes.
Only administrator-level users can issue this command.
e baud rate:
DGS3100 # config serial_port baud_rate 9600
Succes s.
DGS3100#
To pause the scrolling of the console screen after each page when a
sh ow command displays more than one page.
enable clipaging
The enable clipaging command pauses the scrolling of the console
screen at the end of each page when issuing a command which
: 9600
: 8
: None
: 1
: 10 mins
er input.
15
15_minutes]}
− The serial bit rate used to
alues are:
time the console can