About The Label Dispenser - Intermec PC23 User Manual

Chapter 2 — Set Up the Printer

About the Label Dispenser

48
The label dispenser accessory, which includes the Label Taken Sensor,
removes the liner from self-adhesive label stock as each label is printed.
You manually remove the label at the front of the printer.
After you load media, you need to configure the feed adjust settings.
You may need to adjust the recommended values slightly depending
on your media type, supply method, and roll sizes, or because of
individual differences between printers.
Note: Feed adjust values for simulator command languages like ESim,
ZSim, and DSim are preset.
Recommended Feed Adjust Values for the Label Dispenser
Printer Setting
PC23d Start Adjust
Stop Adjust
PC43d Start Adjust
Stop Adjust
PC43t Start Adjust
Stop Adjust
203 dpi 300 dpi Distance
-117 -173 -14.70 mm (-0.58 in)
3 5 -0.46 mm (0.02 in)
-126 -186 -15.8 mm (-0.62 in)
2 3 0.3 mm (0.01 in)
-125 -185 -15.7 mm (-0.62 in)
16 24 2.1 mm (0.08 in)
PC23 and PC43 Desktop Printer User Manual