Jeep 2014 Grand Cherokee Owner's Manual page 409

408 STARTING AND OPERATING
NOTE: If shift conditions/interlocks are not met, or a
transfer case motor temperature protection condition
exists, a "For 4x4 Low Slow Below 3 mph (5 km/h) Put
Trans in N Press 4 Low" message will flash from the
Electronic Vehicle Information Center (EVIC). Refer to
"Electronic Vehicle Information Center (EVIC)" in "Un-
derstanding Your Instrument Panel" for further informa-
tion.
4WD LOW To 4WD HI
With the vehicle at speeds of 0 to 3 mph (0 to 5 km/h), the
ignition switch in the ON position or the engine running,
shift the transmission into NEUTRAL, and press the
"4WD LOW" button once on the transfer case switch. The
"4WD LOW" indicator light in the instrument cluster
will flash and go out when the shift is complete.
NOTE:
• If shift conditions/interlocks are not met, or a transfer
case motor temperature protection condition exists, a
"For 4x4 High Slow Below 3 mph (5 km/h) Put Trans
in N Press 4 Low" message will flash from the Elec-
tronic Vehicle Information Center (EVIC). Refer to
"Electronic Vehicle Information Center (EVIC)" in
"Understanding Your Instrument Panel" for further
information.
• Shifting into or out of 4WD LOW is possible with the
vehicle completely stopped; however, difficulty may
occur due to the mating clutch teeth not being prop-
erly aligned. Several attempts may be required for
clutch teeth alignment and shift completion to occur.
The preferred method is with the vehicle rolling 0 to
3 mph (0 to 5 km/h). If the vehicle is moving faster
than 3 mph (5 km/h), the transfer case will not allow
the shift.