Jeep 2014 Grand Cherokee Owner's Manual page 223

222 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
To change the FCW and Active Braking settings with
Uconnect® 5.0 System Screen — if equipped.
NOTE: The settings can only be changed when the
vehicle is in PARK.
Follow these steps to set the FCW and Active Braking:
1. Press the "+ MORE" hard-key located on the lower
right side of the Uconnect® system.
2. Press the "Settings" soft-key.
3. Press the "Safety/Assistance" soft-key.
4. Press the first "FWD Collision W..." soft-key.
5. Press the "FWD Collision Warning" Far or Near
soft-key for your desired preference. Then press the
back arrow.
6. Press the second "FWD Collision W..." soft-key.
7. Press the "Active Braking" On or Off soft-key.
The default status of FCW is the "Far" setting and the
Active Braking is the "On" setting, this allows the system
to warn you of a possible collision with the vehicle in
front of you when you are farther away and it applies
limited braking. This gives you the most reaction time to
avoid a possible collision.
Changing the FCW status to the "Near" setting, allows
the system to warn you of a possible collision with the
vehicle in front of you when you are much closer. This
setting provides less reaction time than the "Far" setting,
which allows for a more dynamic driving experience.
NOTE:
• The system will retain the last setting selected by the
driver after ignition shut down.
• FCW may not react to irrelevant objects such as
overhead objects, ground reflections, objects not in the