Inserting The Batteries; Using The Buttons - Danfoss living connect Installation And User Manual

Installation Guide
Adapter for RTD valves (accessory)
1.
Place the RTD adapter on the valve as shown.
Adapters for M28 valves (accessories)
Please follow the instructions supplied with the valve adapter for the specific M28 valve.

1.5 Inserting the batteries

Remove the battery cover and insert two AA batteries. Make sure the
batteries are correctly oriented.
Rechargeable batteries must not be used.
When replacing batteries the programme settings will be preserved,
but after two minutes the settings for time and date are reset.
The low battery symbol
batteries run out.
After approx. two weeks the
to 21:00 hrs.
Before the batteries run out living connect® will leave the valve in a
slightly open position to protect the valve from damage.

1.6 Using the buttons

living connect® has two arrow buttons
the display and the menus and to set the temperature*.
The dot button is used to select and confirm.
If the display is off, press either button to activate the display.
*The temperature is usually controlled via Danfoss Link™ CC, but may be
changed at any time using the thermostat's buttons. If this is done, the
thermostat sends a message to Danfoss Link™ CC, instructing it to synchro-
nise the other thermostats in the same room.
Danfoss Heating Solutions
living connect®
is displayed approx. one month before the
symbol will flash 14 times from 19:00
which allow you to navigate
VIIDH102
2.
Hand-tighten the RTD adapter (max. 5 Nm).
7
11/2013