Danfoss living connect Installation And User Manual page 13

User Guide
3.
Bedroom, North
The room contains:
The con guration is invalid:
Room has no devices at all.
Select "Add a device".
5.
Yes
Choose "Yes" to add another device to the
room, choose "No" to continue.
7.
Radiator Con guration
Here you can con gure how the
radiators are placed:
Visible Radiators
Used when radiators are visible.
Covered Radiators
Used when radiators are
covered.
Choose Radiator Type and press
Danfoss Link™ RS room sensor).
Danfoss Heating Solutions
living connect®
Room Devices
0 x
^
Add a device
Remove a device
?
Device was added:
FTS-117
Add another?
No
?
(only with
4.
Press "Begin Registration", and then press and
release on the thermostat.
6.
Choose Heating System and press
8. Once a device has been registered and the
Danfoss Link™ CC is placed in final posi-
tion, you must perform a network test -
see installation guide for Danfoss Link™ CC
VIIDH102
Add Room Devices
1
Keep the device within 1 meter
of the controller and get ready
to begin installation. Press here
when ready:
Begin registration n
2
Press the installation-button on
the device now.
?
Heating System Mode
Decide what the heating system
prioritizes.
Moderate response
Heating with low return
temperature (recommended for
district heating).
Quick response
Fast heating with warm radiators
(recommended for boilers).
?
.
13
11/2013