Danfoss living connect Z Quick Manual

Quick Guide
living connect® Z,
Electronic Radiator Thermostat
Preparation
living connect® Z is an electronic radiator thermostat, intended
for use with water based room radiators. It can be controlled by
a Z-Wave certified controller, which supports the appropriate
command classes.
living connect® Z
living connect® Z is supplied with adapters for Danfoss RA valves
and valves with M30 x 1.5 (K) connections, two alkaline AA bat-
teries and a 2 mm Allen key.
Inserting the batteries
Remove the battery cover and insert two AA
batteries. Make sure the batteries are correctly
oriented.
Rechargeable batteries must not be used.
When replacing batteries the programme set-
tings will be preserved, but after two minutes
the settings for time and date are reset.
Installing living connect® Z
M must be flashing on the display prior to installing.
1. Start by mounting the ap-
propriate adapter.
2. Tighten RA adapter using the
Allen key, hand-tighten the K
adapter (max. 5 Nm).
3. Screw the thermostat onto
the adapter and tighten by
hand (max. 5 Nm).
4. A large M flashes, press
Z-Wave
controller
sensor
RA
K
to fix the thermostat.
VQIDC202 © Danfoss
Including the device to a network
Z-wave
controller
• Ensure living connect® Z is factory reset.
• Activate "Inclusion" on the Z-Wave controller.
• Quickly press and release
• Observe both controller and living connect® Z for status of the
process.
Testing the connection
Press for at least 3 seconds until M is displayed.
Press until LI is displayed.
Press to test the connection.
LI disappears when the connection is made.
If no connection can be made, the alarm symbol
and the antenna symbol
Display and buttons
Battery symbol
The set temperature
Network connection
Lock
Alarm
Use to navigate the display and the menus and to set the
temperature, and use to select and confirm.
12/2014
on living connect® Z.
flashes.
1