Table of Contents
Advertisement
Quick Links
Download this manual
See also:
Installation Manual
Advertisement
Table of Contents
Related Manuals for Danfoss Link FT
Summary of Contents for Danfoss Link FT
- Page 1 MAKING MODERN LIVING POSSIBLE Danfoss Link™ FT Floor Thermostat Installation Manual Danfoss Heating...
- Page 2 Danfoss Link™ FT The Danfoss Link™ FT (Floor Thermostat) is a device for switching the heating element ON/OFF. In connection with a floor sensor it can also measure the temperature in the floor (FTS). Secondly you have the possibility to use the FT as a on and off switch to other equipments manually or by schedule.
-
Page 3: Placement Of Danfoss Link™ Ft
Floor regulation for the room when doing the configura- tion. 2. Total heating: Control of room temperature in living rooms etc. Install the floor sensor and a Danfoss Link™ RS. Choose Combined regulation when doing the configura- tion on the Danfoss Link™ CC. - Page 4 Placement of Danfoss Link™ FT Be aware that temperature control is less accurate without the floor sensor and that all Danfoss Link™ FTs in a room need to havethe same sensor configuration. Danfoss recommends always installing a floor sensor. Do not install floor heating system without a floor sensor...
- Page 5 1. To remove the front cover, gently press the release tabs under the bottom of the thermostat with a screwdriver. Then remove the front. 2. Connect the thermostat according to the connection diagram. Configuration: See Step-by-Step guide in Danfoss Link™ CC instruction manual.
-
Page 6: Troubleshooting
RED LED slow flash Sensor failure Factory reset a Danfoss Link™ FT Turn off power on the safety switch on the front. Hold the install button in while pushing ON the safety switch and keep the install button pressed until the LED gives a red flash... -
Page 7: Disposal Instruction
Disposal Instruction... -
Page 8: Technical Specifications
Technical specifications Operation voltage 180-250 VAC, 50/60 Hz Standby power Max. 1 W consumption Relay: • Resistive load 230 V ~ 15 A / 3450 W cos ϕ = 0.3 Max. 4 A • Inductive load Sensing unit NTC 15kOhm AT 25°C Sensing values: •... - Page 10 Danfoss offers a complete electricians. All work will be invoiced product program with Danfoss in full if Danfoss is required to inspect heating cables or Danfoss heating or repair faults that have arisen as a mats, Danfoss thermostats, Danfoss result of any of the above.
-
Page 11: Warranty Certificate
The 2 Year Danfoss Warranty Warranty Certificate The Danfoss™ Warranty is granted to: Name: Address City: Country: Telephone: Attention: The Warranty Certificate must be completed correctly for the Warranty to be valid. Please read the Warranty conditions above. Type of thermostat:... - Page 12 Article No.: 088L8083 Version - 02.01 Danfoss A/S DK • 7100 Vejle Phone +45 7488 8500 +45 7488 8501 Danfoss Heating Solutions VISGZ102 © Danfoss 09/2009...