Fuji Xerox DocuPrint CP215 Series User Manual page 154

• Wireless LAN (DocuPrint CP215 w Only)
Purpose:
To enable the wireless connection.
Values:
Enable*
Disable
NOTE:
• When you use the USB connection and do not use the wireless connection, you need to disable Wireless
LAN.
• Wireless Status (DocuPrint CP215 w Only)
Purpose:
To display the information on the wireless signal strength. No changes can be made on the operator
panel to improve the status of the wireless connection.
Values:
Good
Acceptable
Low
No Reception
NOTE:
• This item is displayed when the Ethernet cable is disconnected and Wireless LAN is set to Enable.
• Wireless Setup (DocuPrint CP215 w Only)
Purpose:
To configure the wireless network interface.
Values:
Select the access point from the list. The access points are listed starting with the one in the
Select
best communication condition.
Access
WEP Key
PassPhraseEntry
154 Using the Operator Panel Menus
Enables the wireless connection.
Disables the wireless connection.
Indicates good signal strength.
Indicates marginal signal strength.
Indicates insufficient signal strength.
Indicates that no signal is received.
When you select an access point using WEP as the security method,
enter the WEP key. For 64bit keys, enter 10 hexadecimal characters.
For 128bit keys, enter 26 hexadecimal characters.
When you select an access point using WPA, WPA2, or Mixed as the
encryption type, enter the passphrase of 8 to 63 alphanumeric
characters.