Omron BU2002RWL Instruction Manual page 25

2
.Installation and connection
2-2-2. Stationary installation
Perform installation only as shown in the diagrams below.
● H orizontal installation
Attach the included rubber feet for horizontal installation with the included M3 screws and
position the unit horizontally.
For stationary horizontal installation, make sure that this product does not slide or fall.
(Installation is possible without removing the handles on the sides of BU5002RWL; do not re-
move them.)
● U pright installation
(1) Upright installation
Use the upright stands included with the product.
Attach the two upright stands (front and back) for BU2002RWL and BU3002RWL, and three
(front, center, and back) for BU5002RWL with the included screws.
Keep a space of 250 mm or more above the UPS.
(Installation is possible without removing the handles on the sides of BU5002RWL; do not
remove them.)
The batteries for BU5002RWL are in a separate package. Attach the batteries
to the unit before installation. For the attachment procedure, refer to "6-2
Replacing the battery".
13
Note
ESC