Table of Contents
Advertisement
IO BOX Installation
1. Cautions on Installation
Inside IO Box G-Sensor included. Mind following installation guide when install.
-
No matter where you install, maintain level with your vehicle.
-
Install parallelize with vehicle moving direction and X, Y, Z axis on product case.
-
Check moving direction and axis and set DIP switch on front properly.
Ex) If installed following picture
Rear
Set DIP switch as 'Y-' as following picture.
2. Cautions.
Maintaining Level and Dip switch setup should be done before power input to device because IO
box calibrates G-sensor when system initialized. If not maintained level nor wrong dip switch setup,
system may fail to G-Sensor calibration. If failed to calibrate, G-Sensor output value would not be
adjusted again and it send sensor output data from IO box to main unit.
62
Front
Advertisement
Table of Contents
