Monogram ZET1PL1SS Technical Service Manual page 42

2. Replace the light cover by placing its front edge
under the front two tabs in the light housing. Roll
the back edge into place, making sure that it is
fi rmly seated.
Hold locking
clips in place
on lens cover
back edge
Press the light cover into place
Note:
• If the locking clips fell from the glass lens
cover, hold them on the cover, in the correct
position, while replacing the cover on the light
compartment.
• The light cover must be in place when using the
oven.
• For improved lighting inside the oven, clean
the glass cover frequently using a wet cloth.
This should be done when the oven is off,
disconnected from the power supply, and
completely cool.
3. Replace the rack support with the slotted holes
over the rear bolts and the round holes over
the front bolts. Lightly secure with the four nuts
removed earlier, but do not over-tighten or the
enamel could be chipped.
Slotted
holes over
rear bolts
4. Replace the racks. (See
5. Reconnect electrical power to the oven.
Place front edge of
lens cover under
front two tabs
Round
holes over
front bolts
.)
Oven Racks
– 42 –