Monogram ZET1PL1SS Technical Service Manual page 25

2. Fully extend the rack on a table or countertop.
Newspaper may be placed underneath the
rack for easy clean up.
3. If there is debris in the slide tracks, wipe it
away using a paper towel.
Note: Any graphite lubricant wiped away must be
replaced.
g p
4. Shake the graphite lubricant before opening it.
Starting with left slide mechanism of the rack,
place four (4) small drops of lubricant on the two
(2) bottom tracks of the slide close to the bearing
carriers.
Left side
Rack right-side-up
5. Repeat for the right slide mechanism of the rack.
Right side
p y p
Rack right-side-up
6. Open and close the rack several times to
distribute the lubricant.
7. Replace the cap on the lubricant and shake it
again. Turn the rack over and repeat steps 3, 4,
5 and 6.
8. Close the rack. Turn rack right-side-up and
install in the oven.
9. Repeat above steps for each rack.
Note: Do not spray racks with Pam® or other
lubricant sprays.
Rack Support Stud Plates
Each oven utilizes 4 rack ladder stud plates, 2 on
each side. The rack support stud plates are behind
each side access panel. They are held in place by
retaining clips. A damaged or malfunctioning rack
support stud will require replacing the stud plate.
The oven must be removed from the installation
to access the rack support stud plates. (See
.)
Removal
Note: Upon reassembly, ensure displaced insulation
around oven and components is returned to it's
original position.
Rack Support Stud Plate
– 25 –
Oven
Retaining Clip
Rack Stud