Monogram ZET1PL1SS Technical Service Manual page 19

2. On double wall ovens, remove the single Phillips-
head and the four ¼-in. hex-head screws that
hold the heat shield to the side of the oven.
Double Wall Oven
3. Remove the ¼-in. hex-head screws that hold the
side access panel to the oven. The double wall
oven has 10 hex-head screws . The single wall
oven has 14 hex-head screws.
Note: Do not remove the 2 Phillips-head screws
located in the center of the side access panel.
Double Wall Oven
Side Access Panel
Oven Separation (Double Wall Oven)
To separate the double wall oven, remove the
access cover attached to the back of the ovens. It is
held in place by two screws and 4 tabs.
To separate the ovens :
1. Remove the two ¼-in. hex-head screws then
remove the access cover from the 4 tabs.
Double Wall Oven
Tabs
2. Disconnect the 2 wire harnesses and the sensor
harness from the bottom oven.
– 19 –
Access Cover
Screws
Disconnect
Disconnect
Disconnect
(Continued Next Page)