Monogram ZET1PL1SS Technical Service Manual page 41

Oven Light Bulbs
Caution:
• Before replacing the bulb, disconnect electrical
power to the oven at the main fuse or circuit
breaker panel.
• Be sure to let the light cover and bulb cool
completely. Do not touch a hot bulb with bare
hands or a damp cloth.
To remove a light bulb:
1. Remove the racks from the oven. (See
.)
Racks
2. Using an adjustable wrench, remove the four
nuts holding the rack support over the light
assembly.
3. Remove the glass light cover by pulling its
back edge out and rolling it toward you. Do not
remove any screws.
Note: The two locking clips may fall from the glass
light cover. Upon replacement, they will need to be
placed in the correct position on the light cover and
pressed back into the light housing until seated.
4. Using gloves or a dry cloth, remove the burned-
out light bulb by pulling it straight out.
Oven
To replace a light bulb:
Use a new 120-volt Halogen bulb, with G8 pins, not
to exceed 25 watts.
Replacement bulbs may be purchased by calling
800.626.2002. Order Part Number WB25T10064.
Note:
• Higher wattage bulbs will damage your oven.
• Using gloves or a dry cloth, remove the bulb
from its packaging. Do not touch the bulb with
bare fi ngers. Oil from bare fi ngers may cause
hot spots on the glass surface and lead to
premature failure of the bulb. If you do touch the
glass, clean it with alcohol prior to installation.
1. Push the bulb straight into the receptacle all the
way.
– 41 –
(Continued Next Page)