Monogram ZET1PL1SS Technical Service Manual page 35

Bake Element
• The bake element is composed of an inner and
an outer element. It is replaced as one unit.
• The inside element is rated at 1700 watts, has
an approximate resistance value of 33 Ω, and
draws approximately 7.3 amps.
• The outside element is rated at 1000 watts, has
an approximate resistance value of 56 Ω, and
draws approximately 4.3 amps.
• The bake element is located under the oven
fl oor. The bake element terminals are located
behind the left side access panels on both the
single and double wall ovens.
To remove a bake element:
1. Remove the oven from the installation, then
remove the left side access panel for the
appropriate bake element. (See
2. Carefully lift the insulation from the outside of
the oven to access the screws that hold the
bake element cover in place.
Double Wall Oven Left Side Access Panel Shown
3. Remove the two ¼-in. hex-head screws that
.)
Oven Removal
4. On the single wall oven, (and the lower oven
– 35 –
hold the bake element cover to the oven.
Bake Element Cover
on a double wall oven), the black access cover
is held in place by four ¼-in. hex-head screws.
On the double wall oven, the upper oven has an
additional access cover held in place by two ¼-
in. hex-head screws and 4 tabs.
Double Wall Oven Shown
Access Cover
for Upper Bake
Element
Tabs
Screws
(Continued Next Page)