Monogram ZET1PL1SS Technical Service Manual page 24

Oven Racks
WARNING: To avoid possible burns, remove or install
the racks before turning on the oven.
To remove a rack:
1. Make sure the rack is pushed all the way into
the oven.
2. Grasp the rack by both its upper front rail and its
lower front rail and lift straight up to unlock the
front rack locks from the rack supports.
Lift to unlock
front rack
locks from
the rack
support
Front rack lock
3. Firmly holding onto both the upper and lower
front rack rails, pull the rack forward and
remove it from the oven.
Upper
front rail
Lower
front rail
Upper
front rail
Lower
front rail
– 24 –
To install a rack:
1. Place the rear rack locks over and onto the
rack supports. (Five rack positions are available
including the top position.)
2. Slide the rack all the way in until the rear rack
locks are secure on the rear rack supports and
press the front rack locks onto the front rack
supports.
Care and Cleaning
Note:
• The racks may remain in the oven during the
self-cleaning cycle without being damaged.
• Periodically, after several self-clean cycles, the
oven racks may need to be lubricated using
the graphite lubrication shipped with the wall
oven. To order additional graphite lubrication,
call our National Parts Center 800.626.2002 and
reference WB02T10303.
Lubricating an oven rack:
1. Remove rack from the oven.
Front rack lock
(Continued next page)