Monogram ZET1PL1SS Technical Service Manual page 22

To remove the outer door assembly:
1. Remove the door.
2. Place the inner door assembly, gasket side up,
on a protective surface.
3. Remove the three ¼-in. hex-head screws and
the single T15 Torx screw from the bottom of the
outer door assembly.
4. Remove the 4 T15 Torx screws (2 on each side)
from the outer door assembly.
Note: The inner door assembly is heavier than the
outer door assembly.
5. Separate the inner door assembly from the
outer door assembly.
6. Remove the two ¼-in. hex-head screws
that hold the door handle to the outer door
assembly.
Door Shown with Inner Door Assembly Removed
Outer Door Assembly
Caution: Care must be taken if reinstalling the door
handle. Overtightening screws can damage handle.
Hand-tighten screws and make sure handle fi ts
snugly to door panel. (Do not use electric driver.)
To replace the inner door assembly:
1. Remove the outer door assembly. (See
.)
Assembly
2. Remove the 4 T-15 Torx screws (2 on each side)
that attach each door hinge to the inner door.
Carefully turn the door over and remove both
door hinges.
3. Remove the four ¼-in. hex-head screws that
attach the glass and side brackets (glass closet
to the outer door glass) to the inner door.
4. Remove the two ¼-in. hex-head screws that
hold the heat defl ector to the heat barrier.
Door
– 22 –
(Continued next page)