Power Connector Cable - HP 2000 Maintenance And Service Manual

Power connector cable

Description
Power connector cable
Before removing the power connector cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
●
Optical drive (see
●
Keyboard (see
●
Top cover (see
●
USB board (see
Remove the power connector cable:
1. Close the computer.
2. Turn the computer upside down, with the front toward you.
3. Disconnect the power connector cable (1) from the system board.
4. Release the power connector cable from the clips (2) built into the base enclosure.
5. Turn the computer right-side up, with the front toward you.
Battery on page 39), and then remove the following components:
Optical drive (select models only) on page
Keyboard on page 49)
Top cover on page 51)
USB board on page 58)
Spare part number
641394-001
40)
Component replacement procedures 59