Speakers - HP 2000 Maintenance And Service Manual

6. Open the computer.
7. Remove the two Phillips PM2.5×6.0 screws (1) that secure the power connector and bracket to
the computer.
8. Remove the power connector bracket (2).
9. Remove the power connector (3).
Reverse this procedure to install the power connector cable.

Speakers

Description
Speaker Kit (includes left and right speakers and cable)
Before removing the speakers, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
●
Optical drive (see
●
Keyboard (see
●
Top cover (see
●
USB board (see
60 Chapter 4 Removal and replacement procedures
Battery on page 39), and then remove the following components:
Optical drive (select models only) on page
Keyboard on page 49)
Top cover on page 51)
USB board on page 58)
Spare part number
647315-001
40)