Head Restraints - Skoda Octavia Owner's Manual

● The assignment of the radio remote control to a memory button is retained,
however, after reassigning the seats and exterior mirrors.
● After the successful assignment, the turn signal lights flash and an audible
signal will sound as a confirmation. The setting is stored with the memory button
which you have selected.
Retrieving settings of the seat and mirrors
You can retrieve the stored settings either with the memory but-
tons or with the remote control.
Retrieving settings with memory buttons
In order to retrieve the stored setting, you have two possibilities:
–
By pressing briefly: briefly press the desired memory button
–
seat and exterior mirror are moved automatically into the stored positions (this
applies only if the ignition is switched on and the speed is less than 5 km/h).
– Memory keying: Press and hold the desired memory button
enough until the seat and the exterior mirror are moved into the stored posi-
tions.
Retrieving settings with remote control
– If the driver door is closed and the ignition is switched off, briefly press the un-
lock button of the remote control ⇒ p age 36 and then open the driver door.
– The seat and exterior mirrors now move automatically into the stored posi-
tions.
Retrieving setting of exterior mirror for reversing
Turn the rotary knob for the exterior mirror setting into the position 
–
⇒ p age 57 before engaging the reverse gear.
The mirror returns into its initial position, after the rotary knob is moved out of the
position  and put into another position or if the speed is more than 15 km/h.
Emergency Off
You can interrupt the setting operation at any time, if you operate any button of
the driver seat.
Using the system Safety
If the inclination angle of the seat backrest is more than 102° in relation to the
seat cushion, the backrest remains in this position, after reaching this angle, when
retrieving the setting by briefly pressing the memory button. Once the stored an-
 gle is reached, it is necessary to press the memory button and hold it pressed until
the seat is in the stored position.

Head restraints

⇒ f ig.
44. The
B
B pressed long
Fig. 45 Head restraint: Adjusting/pulling out
Best protection is achieved if the top edge of the head restraint is at the same
level as the upper part of your head.
Adjusting the height of a head restraint
Grasp the side of the head restraint with both hands and push it in upward di-
–
rection as desired
Move the head restraint downwards if required by pressing and holding the
–
safety button with one hand
hand the head restraint downwards.
Removing and installing a head restraint
Pull the head restraint up out of the seat backrest as far as the stop (on the
–
rear head restraints fold forward the seat backrest).
Press the locking button in the direction of arrow
–
head restraint out.
– To re-insert the head restraint, push it down into the seat backrest far enough
until you hear the locking button engage.
Driving Tips General Maintenance
Note
⇒ f ig. 45
- left.
⇒ f ig. 45
Breakdown assistance
Seats and Stowage
- right and by pressing with the other
⇒ f ig. 45
- right and pull the
Technical data
63

£