You can close and/or open the sliding/tilting roof by hand if the system is defect.
Position the flat blade of a screwdriver carefully against the rear edge of the
–
cover for the electrical drive at the points of the arrows
Pull the cover down.
–
Insert an Allen key, Group 4, up to the stop into the opening at the point of the
–
arrow
2
and close and/or open the sliding/tilting roof
Press on the cover again by first of all inserting the plastic lugs and then push-
–
ing the cover up.
–
Have the fault rectified by a specialist workshop.
Note
It is necessary after each emergency operation (using Allen key) to move the slid-
ing/tilting roof into the basic position. Here you have to turn the control dial for-
⇒ f ig. 22
ward to the switch position
A
Using the system
Safety
⇒ f ig. 23
1
on the left.
⇒ f ig. 23
on the right.
and press for about 10 seconds.
Driving Tips
General Maintenance
Breakdown assistance
Unlocking and locking
43
Technical data