Connecting Power (If Required); Configuring Your Scanner - Symbol LS2208 Product Reference Manual

1 - 4 Symbol LS2208 Product Reference Guide

Connecting Power (if required)

If your host does not provide power to the scanner, you will need an external power connection to the scanner:
Connect the interface cable to the bottom of the scanner, as described in Installing the Interface Cable on page
1.
1-3.
Connect the other end of the interface cable to the host (refer to your host manual to locate the correct port).
2.
Plug the power supply into the power jack on the interface cable. Plug the other end of the power supply into
3.
an AC outlet.

Configuring Your Scanner

Two methods are available to configure your scanner: using the bar codes included in this manual, or the 123Scan
configuration program.
Refer to Chapter 4, User Preferences
Refer to Chapter 11, 123Scan
the program.
The scanner supports RS-232, IBM 468X/469X, Keyboard Wedge, Wand Emulation, Undecoded Scanner
Emulation, USB, and Synapse to interface to a host system. Each host specific chapter describes how to set up
each of these connections.
for information about programming your scanner using bar code menus.
to configure your scanner using this configuration program. A helpfile is available in