Convert All Bar Codes To Code 39; Convert Code 39 To Full Ascii - Symbol LS2208 Product Reference Manual

Convert All Bar Codes to Code 39

By default, the Wand Emulation Interface sends data to the attached host in the same symbology that was
decoded. This may present a problem for customers with older systems that do not recognize some newer
symbologies (for example, GS1 DataBar).
Enabling this parameter ignores the original symbology that was decoded, and outputs the data as if it were a Code
39 barcode. Any lowercase characters that were in the original data stream are transmitted as uppercase
characters. This also allows ADF Formatting to occur.
If Ignore Unknown Characters is enabled, any characters that do not have a corresponding character in the Code
39 symbology set are replaced by a space.
If Ignore Unknown Characters is disabled, if any characters that do not have a corresponding character are
encountered, the scanner emits an error beep and no data is transmitted.
ADF Note: By default, the Wand Emulation Interface does not allow scanned data to be
NOTE
processed by ADF rules. Enabling this parameter has the side effect of allowing the scanned
data to be processed by the ADF rules

Convert Code 39 to Full ASCII

By default, any characters that do not have a corresponding character in the Code 39 symbology set are replaced
by a space. If this parameter is enabled, the data sent to the Wand Interface will be encoded in Code 39 Full ASCII.
This setting requires that the Host be able to interpret Code 39 Full ASCII data.
This setting applies only if Convert to Code 39 is also enabled.
(Chapter 14, Advanced Data
Enable Convert to Code 39 for Wand Host
*
Disable Convert to Code 39 for Wand Host
*
Disable Code 39 Full ASCII Conversion
Enable Code 39 Full ASCII Conversion
Wand Emulation Interface
Formatting).
9 - 7