Fn1 Substitution Values; Transmit "No Read" Message - Symbol LS2208 Product Reference Manual

13 - 6 Symbol LS2208 Product Reference Guide

FN1 Substitution Values

The Wedge and USB HID Keyboard hosts support a FN1 Substitution feature. When enabled any FN1 character
(0x1b) in an EAN128 barcode is substituted with a value. This value defaults to 7013 (Enter Key)
To select a FN1 Substitution Value, scan the bar code below.
1.
Look up the keystroke desired for FN1 Substitution in the ASCII Character Set table for the currently installed
2.
host interface. Enter the 4-digit "ASCII Value" by scanning each digit in the
To correct an error or change the selection, scan CANCEL.
3.
To enable FN1 Substitution for Wedge, scan the Enable Keyboard Wedge FN1 Substitution bar code on
5-15.
To enable FN1 Substitution for USB HID Keyboard, scan the Enable USB Keyboard FN1 Substitution bar code on
page 7-13.

Transmit "No Read" Message

Scan a bar code below to select whether or not a "No Read" message is transmitted. When enabled, the
characters NR are transmitted when a bar code is not decoded. When disabled, if a symbol does not decode,
nothing is sent to the host.
Set FN1 Substitution Value
Enable No Read
*
Disable No Read
Appendix D, Numeric Bar Codes.
page