Convert All Bar Codes To Code 39 - Symbol LS9203 Product Reference Manual

8 - 10 Symbol LS9203/LS9203i Product Reference Guide

Convert All Bar Codes to Code 39

By default, the Wand Emulation Interface sends data to the attached host in the same symbology that was
decoded. This may present a problem for customers with legacy systems that do not recognize some newer
symbologies (for example, GS1, formerly RSS).
Enabling this parameter ignores the original symbology that was decoded, and outputs the data as if it were a Code
39 barcode. Any lowercase characters that were in the original data stream are transmitted as uppercase
characters. This also allows ADF Formatting to occur.
If Ignore Unknown Characters is enabled, any characters that do not have a corresponding character in the Code
39 symbology set are replaced by a space.
If Ignore Unknown Characters is disabled, if any characters that do not have a corresponding character are
encountered, the scanner emits an error beep and no data is transmitted.
ADF Note: By default, the Wand Emulation Interface does not allow scanned data to be processed by ADF rules.
Enabling this parameter has the side effect of allowing the scanned data to be processed by the ADF rules (See
Chapter 13).
Enable Convert to Code 39 for Wand Host
*
Disable Convert to Code 39 for Wand Host