D Transmitting A Group Call - Icom IC-M604A Instruction Manual

6
DSC OPERATION
■ Transmitting DSC Calls (Continued)

D Transmitting a Group Call

The Group Call function allows you to transmit a DSC signal
to only a specifi c group.
q Enter "
❮ ❯ ➪
(Push [MENU])
w Rotate [SELECTOR] to select the desired pre-pro-
grammed group address or "
push [ENT].
• The ID code for the Group Call can be set fi rst. (p. 17)
• When "
for the group you wish to call using keypad keys.
5GNGEV 5GNGEV #FFTGUU
/CPWCN +PRWV /CPWCN
+EQO +EQO
)TQWR # )TQWR #
%.4 'ZKV %.4
e Rotate [SELECTOR] to select a desired intership channel
or "
• Intership channels are already preset into the transceiver in
recommended order.
The fi rst one digit is specifi ed '0' for a Group ID.
The fi rst two digits are '0' for any Coast station ID.
26
" in the DSC menu.
❮ ❯
(Rotate [SELECTOR], then push [ENT].)
" is selected, set the 8 digit ID code
&5% /GPW &5% /GPW
#FFTGUU
+PRWV
'ZKV  '06 1- '06 1-
," then push [ENT].
5GNGEV +PVGTUJKR 5GNGEV
," then
r Push [ENT] to transmit the Group Call.
• If Channel 70 is busy, the transceiver stands by until the chan-
nel becomes clear.
t After the Group Call has been transmitted, the following
message is displayed.
y Push [CLR] to exit and the transceiver automatically se-
lects the intership channel specifi ed in step e.
• Even if [CLR] hasn't been pushed, the transceiver
selects the specified intership channel in step e after
cally
2 seconds of inactivity.
&5% /GPW &5% /GPW
+PVGTUJKR %* %*
 
 
 
 
%.4 'ZKV %.4 'ZKV  '06 1- '06 1-
&5% /GPW &5% /GPW
)TQWR )TQWR %CNN %CNN 4GCF[ 4GCF[
%.4 %.4 'ZKV 'ZKV  '06 1- '06 1-
)TQWR %CNN )TQWR %CNN
6: %QORNGVG 6: %QORNGVG
%.4 %.4 'ZKV 'ZKV
automati-