Husky HD1500 Operator's Manual page 20

PROBLEM OR CONCERN
No water coming out of
Wand
Trigger will not move
Unit will not start
Note: Unit will only start when
trigger is depressed.
Unit stops while operating
Unit will not stop when trig-
ger is released
English
POSSIBLE CAUSE
Gun/Hose Assembly is defec-
tive
Gun Safety Lock in engaged
Unit is not turned on
Loose or disconnected Plug
Defective GFCI Plug
Extension Cord length or gauge
incorrect
Gun trigger not operating pro-
perly
Defective Gun
Tripped Pressure washer Ther-
mal Switch
Defective ON/OFF Switch
Screen filter is clogged
Garden Hose is kinked or
leaking water
Wand is malfunctioning
Gun is not operating properly
20
SOLUTION
Attach the Gun/Hose to the front of the unit with no
wand attached to the Gun. Squeeze the trigger of
the gun to ensure that water comes out of the front
of the Gun at a rate equal to the Garden Hose. If no
water comes out of the Gun, remove the gun and
the hose to ensure that water flows out of the pump.
If it does, the gun will need to be replaced. Contact
us at customerservice@huskypowerwash
er.com or order a replacement directly online at
www.huskypowerwasher.com.
Release Safety Lock as instructed in Manual.
Press ON/OFF Switch into ON position.
Reconnect Plug.
Perform GFCI reset procedure as instructed in
Section 2.0. If the Plug does not reset it will
need to be replaced. Contact us at custome
rservice@huskypowerwasher.com or
order a replacement directly online at www.
huskypowerwasher.com.
Use proper Extension Cord as instructed in section
2.0.
Contact us at customerservice@huskypow
erwasher.com or order a replacement directly
online at www.huskypowerwasher.com.
Remove the Gun and Hose assembly from the front
of the unit. Aim water stream away from electric
source and switch the unit into the ON position.
If the unit starts and water comes out of the front,
the Gun may need to be replaced. Contact us at
customerservice@huskypowerwasher.
com or order a replacement directly online at
www.huskypowerwasher.com.
Allow to cool and restart unit.
Contact us at customerservice@huskypow
erwasher.com or order a replacement directly
online at www.huskypowerwasher.com.
Clean the Screen filter as instructed in the sec-
tion 6.4.
Make sure the Garden Hose is laid out flat and
there are no kinks in it. The hose should not be
wrapped on a storage wheel. Make sure the
faucet is open all the way and there is a full
volume of water reaching the unit.
Test both wands to ensure that one is not mal-
functioning.
Remove Wand from the Gun and squeeze trigger to
ensure that the water is coming out of the front of the
Gun at a rate equal to the Garden Hose.