Activating Auto Balance - Hunter 42798-01 Owner's Manual

7.3
Loosen (DO NOT REMOVE) the blade-to-arm screws (47) that are holding
the shipping bumpers in place. Push the shipping bumpers in, then lift
them off.
Red Retaining
Screws
8.1
If you are using one of the enclosed pipe/ball assemblies, it is now time
for you to activate the Auto Balance
TM
retaining screws. Rotate the blades slowly until one of the red retaining
screws is visible through the notch in the mounting plate. Remove the
retaining screw from the bottom of the fan housing using a screwdriver.
Repeat this process for all 5 retaining screws.
7 • Assembling the Blades (continued)
47
8 • Activating Auto Balance
Note: After the
retaining screws
are removed,
the blades will
feel loose. This
is normal, as
loose blades are
a characteristic
of the Auto
Balance TM
system.
system by removing the five red
42798-01 • 09/16/09 • Hunter Fan Company
7.4
98
Slide the blade arms (98) onto the blade-to-arm screws (47). Tighten the
blade-to-arm screws (47) as tight as possible with a screwdriver.
TM
8.2
If you are using a pipe/ball assembly longer than 6 inches, leave the
retaining screws in their place and continue the installation process.
15 15
47