Hunter 42798-01 Owner's Manual page 6

2 • Installing the Ceiling Mounting Plate (continued)
2.5
Align the slotted holes in the ceiling mounting plate (2) with the pilot
holes you drilled in the wood support structure. For proper alignment, use
slotted holes directly across from each other.
Tabs
2.7
2
For Angled Ceilings: Be sure to orient the ceiling mounting plate (2) so
that the two tabs are pointing toward the ceiling peak.
Note: The
isolators must be
flush against the
ceiling. A loose
ceiling mounting
plate will result
in improper
operation
of the Auto
Balance™system.
2
Place a flat washer (68) on each of the two 3" wood screws (65). Insert
the screws into the slotted holes in the ceiling mounting plate (2) into the
pilot holes you drilled. Tighten the screws (65) into the 9/64" pilot holes;
do not use lubricants on the screws. Do not over tighten.
Toward
Ceiling Peak
Unbundle the wires from the fan.
Note: Your Hunter fan comes with an optional pipe/ball assembly
extension pipe. If you are hanging the fan on a ceiling higher than 10 feet
tall and you would like to use the enclosed optional pipe/ball assembly,
follow Steps 3.5
6 6
42798-01 • 09/16/09 • Hunter Fan Company
2.6
65
2.8
–
3.9.
2
68