Hunter 42798-01 Owner's Manual page 22

Operation
The fan pull chain controls power to the fan.
• The pull chain has four settings in sequence: High, Medium,
Low, and Off.
• Pull the chain slowly to change settings.
• Release slowly to prevent the chain from recoiling into the
blades.
• The chain uses a breakaway connector that separates if the
chain is jerked. If this happens, simply reinsert the chain into
the connector.
The light pull chain controls the power to the light fixture.
• The chain has two settings: ON and OFF.
Problem: Noisy operation
• Tighten the blade assembly screws and blade iron armature
screws until snug.
• Check to see if a blade is cracked. If so, replace all the blades.
Problem: Excessive wobbling
If your fan wobbles when operating, use the enclosed balancing
kit and instructions to balance the fan.
Tighten all blade iron screws.
Turn power off , support fan very carefully, and check that the
hanger ball is properly seated.
If you have tried these troubleshooting solutions and still
have trouble, visit our Web site at:
http://www.hunterfan.com.
Hunter Fan Company
7130 Goodlett Farms Parkway #400
Memphis, Tennessee 38016
10 • Operation & Maintenance
Troubleshooting
22
42798-01 • 09/16/09 • Hunter Fan Company
Problem: Nothing happens; fan does not move.
• Turn power on, replace fuse, or reset breaker.
• Loosen canopy, check all connections according to the wiring
the fan section.
• Check the plug connection in the switch housing.
• Push motor reversing switch fi rmly left or right to ensure that
the switch is engaged.
• Pull the pull chain to ensure it is on.
• Remove the shipping bumpers.
Other Hunter Products
Oscillating Fans
Air Purifiers
Thermostats
To learn more about Hunter Fan Company
products, please see our Web page at:www.
hunterfan.com
Humidifiers
Bath Fans
Ceiling Fans