Footboard Converter Xlt Max - Invacare XLT Max User Manual

5.6.2 Footboard converter XLT Max

The footboard converter is a sturdy construction in
three parts that is easily dissassembled to allow for
transfers into and out of the wheelchair.
Make sure that the feet are placed as far out as pos-
sible before the middle part is installed or removed.
Otherwise the pressure on the footplates might cause
the footboard to break.
B
C
Caution! Risk of pinching
When handling the footboard there
is a risk of pinching your fingers.
Make sure that no pressure is on the
footboard when it is being handled
and adjusted.
To remove the middle part, press the button (A).
Slide the right-hand side footplate (B) sideways.
Press button (C) and remove the middle part.
Make sure that the feet are placed as far out as pos-
sible.
XLT
Invacare ®
The middle part of the footboard converter is installed
by inserting the fasteners into one of the footplates
and then on the other side. A small marking (hole)
on the part should be facing backwards (B) (towards
the wheelchair) when the footboard is assembled
correctly.
A
The footplates can be flipped up to further facilitate
transfers.
B
A
A
Warning! Risk of injury
If the middle part is not installed cor-
rectly it will fall out and the user can
get hurt.
The buttons (A) should pop out when
the middle part is installed correctly
and turned the right way.
Caution! Risk of breakage
The footboard is not designed for
lifting the chair. Do not take hold on
the footboard if you need to lift the
chair.
23