Trunk Support - Invacare XLT Max User Manual

Tool: 5 mm Allen key
Anti-tip device, extended
The anti-tip device also acts as a step tube. It is height
adjustable and easy to adjust.
This extended anti-tip device is primarily used when
an extended rear wheel attachment is used. It can
also be used with the standard rear wheel attach-
ment.
1. Attach the anti-tip device to the frame tube with
brackets and screws (A).
2. Lift the spring loaded button and select the re-
quired height. Ensure that the anti-tip device
locks into its new position.
The rearwheel attachment cannot be
mounted in the lowest position (B)
when the extended anti-tip device is
used.
Never forget to fold down the anti-
tip devices or the wheelchair may tip
over.
The distance between the anti-tip
wheel and the ground, and the dis-
tance between the anti-tip wheel and
rear wheel, should be approx. 5 cm.
For safety reasons we recommend
the use of two anti-tip devices
32
A
B

5.15.2 Trunk support

The trunk support can be swung away or lifted out of
its holder. The height, depth and sideways positions
are easy to adjust.
Tool: 4 mm Allen key
Tool: 4 mm Allen key
Height adjustment
1a. Adjust the height by first slackening the screws (A)
with an Allen key and then sliding the holder (B)
up or down to the required position. Re-tighten
screws.
b.The bracket (C) can also be adjusted up or down by
first removing the screws (D) on the attachments
with an Allen key. Move the bracket up or down to
the required position. Re-tighten screws.
A
B
C
D
XLT
Invacare ®