Appliance Preparation; Installing Outside Air Kit Damper Assembly; Gas And Electrical Connections - Heat & Glo SL-750TV-IPI-E Owner's Manual

7 7

Appliance Preparation

CAUTION
Sharp Edges
• Wear protective gloves
and safety glasses dur-
ing installation.
A. Installing Outside Air Kit Damper Assem-
bly
WARNING
Asphyxiation Risk.
Fire Risk.
Do NOT draw outside combustion air from:
• Wall, fl oor or ceiling cavity.
• Enclosed space such as an attic or garage.
• Close proximity to exhaust vents or chimneys.
Fumes or odor may result.
• Remove and discard cover plate or knockout from side
of appliance.
• Open air kit damper slightly.
• Locate door hinge toward back of appliance (see Figure
7.1).
D O O R
H A N D L E
Figure 7.1 Damper Assembly and Handle
16
H IN G E
Heat & Glo • SL-550 / 750 / 950TV-IPI-E • 2119-900 Rev. G • 9/08
Figure 7.2 Outside Air Kit Installation
• Attach damper assembly to appliance using screws
provided (see Figure 7.2).
• Insert narrow end of handle through tab and into upper
slot of door.
• Check handle operation. Pull handle out to open, and in
to close.
B. Gas and Electrical Connections
If applicable, ensure that gas and electrical connections are
installed at this time. Refer to Sections 9 (Gas Information)
and 10 (Electrical Information).