Table of Contents
Advertisement
6
Appliance Preparation
CAUTION! Risk of Cuts, Abrasions or Flying Debris.
Wear protective gloves and safety glasses during
installation. Sheet metal edges are sharp.
A. Top Standoff Preparation
1. Rotate the four (4) top standoffs up into vertical position.
Push the standoff support tab on each standoff toward
the center of the appliance and fasten it in place using
the supplied screw and pilot hole. See Figure 6.1.
Standoff Shipping Position
Figure 6.1 Standoffs Shown in Vertical Postion
B. Vent Collar Preparation
1. Remove and discard the shipping screw. Bend the pipe
heat shield up into vertical position. See Figure 6.2.
2. Position the pipe heat shield up against the header and
attach to header with two screws.
WARNING! Risk of Fire! Pipe heat shield must be fas-
tened to header.
SHIPPING SCREW
Heat Shield Shipping Position
Figure 6.2 Heat Shield Shown Installed
Heat & Glo • MEZZO36-B/ST-B, MEZZO48-B/ST-B, MEZZO60-B/ST-B, MEZZO72-B/ST-B Installation Manual • 2300-973 Rev. R • 12/18
34
Standoff Installation Position
HEAT SHIELD
Heat Shield Installation Position
3. Place a vent section on the starting collar.
WARNING! Risk of Fire! DO NOT attach elbow directly
to the appliance.
• The MEZZO36-B/MEZZO36ST-B, MEZZO48-B/
MEZZO48ST-B and MEZZO60-B/MEZZO60ST-B
require a minimum of 24 inches of vertical venting before
attaching any elbow to the appliance.
• The MEZZO72-B/MEZZO72ST-B requires a minimum of
36 inches of vertical venting before attaching any elbow
to the appliance.
4. Place the 1/8 inch thick, square fiberglass gasket over
the initial vent section.
5. Place the fiberglass rope ring over the gasket. Ensure
both the gasket and the rope ring are seated on the top
of the appliance. See Figure 6.4.
BOTTOM PANEL SCREW LOCATIONS
Figure 6.3 Location of Fiberglass Rope Ring
GASKET
ROPE RING
Figure 6.4 Fiberglass Rope Ring Installed
PIPE HEAT SHIELD
FIBERGLASS ROPE RING
Advertisement
Table of Contents
