Finishing; Mantel Projections - Heat & Glo SL-750TV-IPI-E Owner's Manual

11 11

Finishing

A. Mantel Projections
Figure 11.1 shows the minimum vertical and corresponding
maximum horizontal dimensions of appliance mantels or
other combustible projections above the top front edge of
the appliance.
6
5
4
3
TOP OF HOOD OR FIREPLACE OPENING
Note: All measurements are in inches.
Figure 11.1 Clearances to Mantels or other Combustibles above
Appliance
3-1/2 in.
1/2 in.
NON-COMBUSTIBLE ZONE
Figure 11.2 Non-Combustible Zone
24
CEILING
12
11
10
9
8
7 32
13
12
11
10
9
8
7
6
5
4
1/2 in.
SHEETROCK
NON-COMBUSTIBLE
BOARD SHIPPED
WITH APPLIANCE
Heat & Glo • SL-550 / 750 / 950TV-IPI-E • 2119-900 Rev. G • 9/08
TOP VIEW
2-7/8 IN.
MINIMUM
Note: Clearance from
opening Alcove/Mantel leg.
Figure 11.3 Clearances to Mantel Legs or Alcove Wall Projection
(Acceptable on both sides of opening.)
TOP VIEW
5-3/8 IN.
MINIMUM
Note: Clearance from
opening Alcove/Mantel leg.
Figure 11.4 Clearance to Wall Projection
(Acceptable on one side of opening.)
1/2 IN.
MINIMUM
3 FT.
MAXIMUM
1/2 IN.
MINIMUM
UNLIMITED