Table of Contents
Advertisement
6 6
Appliance Preparation
A. Vent Collar Preparation
CAUTION! Risk of Cuts, Abrasions or Flying Debris.
Wear protective gloves and safety glasses during instal-
lation. Sheet metal edges are sharp.
Figure 6.1 Seal Cap in Position
(Generic Fireplace Shown)
Figure 6.2 Remove the seal cap.
(Generic Fireplace Shown)
WARNING! Risk of Fire! DO NOT remove the installed
piece of insulation from the firebox top on 8000CMOD-
IFT models. Overheating will occur.
1. Remove the seal cap as shown in Figure 6.2.
2. Locate the fiberglass gasket in the manual bag. Attach
the gasket to the outer wrap using two self-tapping
screws. This creates a seal between the first vent
component and the outer fireplace wrap. Figure 6.3
shows the gasket in place.
3. Secure the first section of venting to the firebox by at-
taching to the starting collar with screws. See Figure
6.4.
Heat & Glo • 6000CMOD-IFT, 8000CMOD-IFT Installation Manual • 2509-980 Rev. L • 6/20
Figure 6.3 Gasket in Place (Generic Fireplace Shown)
Note: Vent attachment method varies by model.
STARTING COLLAR
Figure 6.4 Starting Collar (Generic Fireplace Shown)
31
Advertisement
Table of Contents
