Care And Maintenance - BBQ GSS3219A Instruction Manual

5 burner lp gas barbecue grill

Table of Contents

IMPORTANT

Always allow to completely cool off before covering your grill to prevent corrosion from condensation.

CAUTION:

All cleaning and maintenance should be done when the grill is cool, with the fuel supply turned off at the control dial and

the propane cylinder disconnected. DO NOT clean any grill part in a self-cleaning oven. The extreme heat will damage

the finish.

Cleaning

Burning off the grill after every use (approx. 15 minutes) will keep excessive food residue from building up. Clean the

grill before and after cooking is recommended.

Recommended cleaning materials :

Mild dishwashing liquid detergent

Nylon cleaning pad

Paper clip

Compressed air

DO NOT use cleaners that contain acid, mineral spirits or xylene.

Outside surfaces

Use a mild dishwashing detergent and hot water solution to clean. Rinse thoroughly with water.

Inside surface

If the inside surface of the grill lid has the appearance of peeling paint, baked on grease has turned to carbon and is

flaking off. Clean thoroughly with a strong solution of detergent and hot water. Rinse with water and allow it to

completely dry.

Interior of grill bottom – Remove residue using brush, scraper and/or cleaning pad. Wash with a dishwashing detergent

and hot water solution. Rinse with water and let dry.

Cooking Grates – The porcelain grates have a glass-like composition that should be handled with care. Use a mild

dishwashing detergent or baking soda and hot water solution. Non-abrasive scouring powder can be used on stubborn

stains. Rinse with water.

Heat Plates – Clean residue with wire brush and wash with soapy water. Rinse with water.

Grease Cup – Periodically empty the grease cup and clean with a dishwashing detergent and hot water solution.

Cleaning the Burner Assembly

Turn gas off at the control knobs and propane tank.

Remove cooking grates and heat plate.

Remove grease cup.

Remove burner by unscrewing nut from beneath burner "foot" using a screwdriver and pliers.

Lift burner up and away from the gas valve orifice.

Clean inlet (venturi tube) of burner with small bottle brush or compressed air.

Remove all food residue and dirt on outside of burner surface.

Clean any clogged ports with a stiff wire (such as an opened paper clip).

Inspect burner for damage (cracks or holes). If damage is found, replace with a new burner. Reinstall burner.

Make certain the gas valve orifices are correctly positioned, pointing straight into burner inlet (venturi tube). Also,

check position of spark electrode.

GSS3219A

Instruction Manual