BBQ GSS3219A Instruction Manual page 12

Step 13 (Partition board assembly)
Place the partition board (V) onto the end of heat
a)
plate support as shown.
b) Align the hole on the partition board with the hole on
the bottom of fire box, then insert one M6 x 15 bolt (BB)
with one flat washer (EE), tighten the bolt using the
screwdriver provided.
M6 x 15 Bolt
BB
M6 Flat Washer
EE
GSS3219A
Instruction Manual
1 PC
1 PC
11
Step 12 (Side burner assembly)
a) Open the side burner lid and place the side
burner frame (O) on the right side shelf.
Make certain the venturi tube is connected
properly with valve.
b) Align the four holes on the side burner
frame (O) with the four holes on the right
side shelf. Insert one bolt (CC) into each
hole and place one flat washer (GG), one
spring washer (HH) and one nut (II) onto
each bolt from the bottom of right side
shelf, tighten all bolts by hand.
c) Connect the side burner ignition wire/
cable by sliding it onto the electrode on the
side burner frame (O).
d) Go back and tighten all bolts using the
screwdriver provided.
M4 x 15 Bolt
CC
M4 Flat Washer
GG
M4 Spring Washer
HH
M4 Nut
II
Step 14 (Heat plate, cooking grid and warming rack
assembly)
a) Place the heat plates (P) onto the heat plate support.
b) Place the cooking grids (Q) upon the heat plates.
c) Place the warming rack (R) on the warming grid support
as shown.
d) Close the top lid.
4 PCS
4 PCS
4 PCS
4 PCS