Table of Contents
Advertisement
Confirm that the burner is properly lit and that the flame pattern is as desired (see fig. A, B and C below for the proper
flame patterns). If the flame pattern is other than normal, consult the Troubleshooting on page 22 for corrective action.
FIG. A
Normal: Soft blue flames with yellow
tips between I inch - 2 inches high.
Burner installation and adjustment
End edge should face towards upside.
Lighting Infrared Burner
1.
Open lid while lighting burner.
2.
Make sure the control knob is locked in the OFF position.
3.
Open cylinder valve.
4.
Push and turn control knob to HIGH setting. After lighting, please observe the ceramic plate on the surface of burner; it
should feel warm after 5-10 seconds and the color of the ceramic plate should turn red in 2-3 minutes.
5.
If burner does not light on the first try, turn the control knob to its OFF position and wait 5 minutes for gas to clear
before trying again. If burner flame goes out during operation, immediately turn the gas OFF and open lid to let the gas
clear for about 5 minutes. Attempt to re-light.
6.
Clean your grill after each use, DO NOT use abrasive or flammable cleansers, as it will damage the parts of this
product and may start a fire. Clean with warm soapy water.
Observing the Heat and Color of the Infrared Ceramic Burner when lit
●
Flame of infrared burner might be visible in shaded area.
●
After burner is lit, it should feel warm in 5-10 seconds and color of the ceramic plate turns red in approximately 2-3
minutes.
Flare-ups
"Flare-ups" sometimes occur when food drippings fall onto the hot heat distribution plate or burners and ignite. Some
flaring is normal and desirable as it helps impart the unique flavors associated with grilled foods. Controlling the intensity of
the flare-ups is necessary, however, in order to avoid burned or unevenly cooked foods and to prevent the possibility of
accidental fire.
WARNING:
Always monitor the grill closely when cooking and turn the flame level down to LOW or OFF if flare-ups intensify.
GSS3219A
Instruction Manual
FIG. B
Out of adjustment: Noisy hard blue
flames – too much air.
1. Release the screw on venturi
tube.
2. Adjust the flame by turning the
collar on head of venturi tube from
back side of the grill and do not
take apart the venturi tube.
3. Tighten the screw and make
certain it is secured.
16
FIG. C
Poor combustion: Wavy, yellow
flames- too little air.
1. Overlap 14 mm between
venturi tube and nozzle
when assembling.
2. Keep the center line of
venturi tube and nozzle
on one line.
Advertisement
Table of Contents
