Headlamp High/Low-Beam Changer; Flash-To-Pass; Windshield Wipers - Chevrolet Malibu 2010 Owner's Manual

Headlamp High/Low-Beam Changer

To change the headlamps from low beam to high
beam, push the turn signal/multifunction lever away
from you.
This instrument panel cluster light
high beam lamps are turned on while the ignition is
in ON/RUN.
To change the headlamps from high beam to low beam,
pull the turn signal lever toward you.

Flash-to-Pass

This feature lets the high-beam headlamps be used to
signal a driver in front of you that you want to pass.
Pull the turn signal/multifunction lever toward you until
the high-beam headlamps come on, then release
the lever to turn them off.
3 comes on if the

Windshield Wipers

The windshield wiper lever is on the right side of the
steering wheel.
Move the lever to control the windshield wipers.
9 (Off): Turns the windshield wipers off.
(Intermittent; Speed Sensitive Wipers): For
&
intermittent or speed sensitive operation. While in this
position, turn the x band up or down to vary
frequency.
4-5