Starting And Operating Your Vehicle; New Vehicle Break-In; Ignition Positions - Chevrolet Malibu 2010 Owner's Manual

Starting and Operating Your
Vehicle

New Vehicle Break-In

Notice: The vehicle does not need an elaborate
break-in. But it will perform better in the long run if
you follow these guidelines:
•
Do not drive at any one constant speed, fast or
slow, for the first 500 miles (805 km). Do not
make full-throttle starts. Avoid downshifting to
brake or slow the vehicle.
•
Avoid making hard stops for the first 200 miles
(322 km) or so. During this time the new brake
linings are not yet broken in. Hard stops
with new linings can mean premature wear and
earlier replacement. Follow this breaking-in
guideline every time you get new brake linings.
•
Do not tow a trailer during break-in. See Towing
a Trailer on page 5-30 for the trailer towing
capabilities of your vehicle and more
information.
Following break-in, engine speed and load can be
gradually increased.
3-22

Ignition Positions

To shift out of P (Park), the ignition must be in ON/RUN
or ACC/ACCESSORY and the brake pedal must be
applied.
Notice: Using a tool to force the key to turn in the
ignition could cause damage to the switch or
break the key. Use the correct key, make sure it is
all the way in, and turn it only with your hand. If the
key cannot be turned by hand, see your
dealer/retailer.
9 (LOCK/OFF): This position locks the ignition. It also
locks the transmission. The key can only be removed
in LOCK/OFF.
The ignition switch has
four different positions.