Omron Powli BU1002SW Instruction Manual page 32

(2) When using the included UPS monitoring software and the Windows standard UPS service, use a con-
nection cable to connect the unit to the PC.
See also "7. Using the UPS monitoring software and Contact Signal" on page 54.
* If you do not use the UPS monitoring software and Contact Signal, this step is not required.
(3) When the installation and connection is complete, connect the AC Input Plug of the UPS to a wall outlet
(commercial power).
Make sure to connect the AC input plug of the unit into a wall outlet
(commercial power) with rated input voltage (200 to 240V AC).
● Connecting to a wall outlet (commercial power) of a different rated input voltage may
result in fi re.
● The unit may fail.
<BU3002SW>
● The UPS has been charged prior to shipment. However, the backup time becomes shorter when
using it for the fi rst time due to spontaneous discharge.
We recommend charging the UPS before using it.
When the AC input plug is connected to a wall outlet (commercial power), the battery automati-
cally starts charging, taking up to 8 hours to complete (24 hours when an additional battery unit
is connected).
● You can perform "2-4 Checking the operation" on page 20 also before charging the battery.
Input plug (L6-20P)
(Front view)
Grounding terminal
Connect the ground wire to the Grounding terminal.
When one wire is used to ground the AC input power
supply, make sure to use this unit's N terminal (phase)
side as the ground.
A misconnection may result in malfunction.
●
Caution
PC
200 to 240 VAC
3P receptacle
Caution
1002 3002
BU SW / BU SW
1
2
3
4
5
6
7
8
9
10
19