Wire Tie - NordicTrack INCLINE TRAINER X5I INTERACTIVE User Manual

1. Make sure that the power cord is unplugged.
With the help of a second person, tip the incline
trainer onto its left side. Have the second per-
son hold the incline trainer to prevent it from
tipping.
Attach four Base Feet (10) and two Base Foot
Spacers (11) to the Base (80) with four #8 x 1"
Tek Screws (2) in the locations shown. Be care-
ful not to overtighten the Tek Screws.
2. Identify the Right Upright (79), which is marked
with a "Right" sticker. Hold the Right Upright
near the incline trainer.
See the lower inset drawing. Tie the wire tie in
the Right Upright (79) around the end of the
Upright Wire (78). See the upper inset draw-
ing. Then, pull the other end of the wire tie until
the Upright Wire is routed out the side hole in
the top of the Right Upright.
Orient the Right Upright (79) as shown. Attach
the Right Upright to the Base (80) with two 3/8"
x 3 1/2" Bolts (5) and two 3/8" Star Washers (8).
Start both Bolts in the two holes nearest the
Base Foot (10) as shown, and then tighten
each of them. Be careful not to pinch the
Upright Wire (78).
With the help of a second person, tip the incline
trainer onto its right side. Have the second per-
son hold the incline trainer to prevent it from
tipping.
Attach the Left Upright (not shown) as de-
scribed above. Note: There are no wires on the
left side.
1
11
10
10
11
2
79
78
Wire
Tie
7
2
10
80
2
79
Wire
Tie
80 10
78
78
10
2
2
78
8
5
79
Wire
Tie