Create A Group; Setting A Secondary Keypad (Controller) - Honeywell Tuxedo Touch User Manual

Create a Group

Multiple Z-wave devices can function together in a group. Up to 50 groups can be created. Create a Group as follows:
ICON
1. Press the Automation icon and then press
the Group Setup icon.
2. Press the Add icon and enter a "Group
Name" on the data entry keyboard.
3. Press GO.
4. Select the device(s) to be enabled in this
group and press the Save icon.
5. Press the Edit icon to rename the group.
Group Setup Icons
Delete
Edit

Setting a Secondary Keypad (Controller)

After all Z-Wave devices have been enrolled into the Primary Keypad (Controller #1), the device information can be downloaded
to a Secondary Keypad (Controller #2). Keep the controllers within 10 feet of each other, apply power to Controller #2 and do the
following:
ICON
1. At Controller #1:
a) Press the Automation icon from the
"Home" screen and then press the
Z-Wave Setup icon to display the
"Z-Wave Device Management" screen.
2. At Controller #2:
a) Remove any Z-Wave devices that have
been added.
b) Press the Z-Wave Primary icon (located
in the lower right side of the screen).
c) Select Yes to change this keypad to a
Secondary Controller.
3. At Controller #1: Press the Add icon.
4. At Controller #2: Press the Add icon.
5. To edit information, press the Z-Wave Edit
icon.
Automation (cont'd)
ACTION
Group names (i.e., All, etc.) are displayed across the top to the screen.
Use the Data Entry Keyboard to enter all required information.
• Press the Up Arrow key to switch to capital letters
• Press the X key to delete
• Press the ABC/.?123 key to switch between numerals and
• Press GO to return to the "Add New Camera" screen.
If settings were changed, a pop-up window displays:
Settings saved. Select OK to save.
Add
Save
ACTION
41
NOTES
symbols/characters.
NOTES
When the Primary Controller icon is pressed, the message is displayed:
"Please remove all Z-wave devices from network first"
The message is displayed: "Scanning for Devices"
The message is displayed: "Updating Devices. Please Wait"
When the device information from the Primary Controller is downloaded to
the Secondary Controller, the Secondary Controller displays:
"Controller Add Success"
The Primary Controller displays: "Device Added Successfully"