Remove All Z-Wave Devices; Abort A Z-Wave Action; Create A Scene - Honeywell Tuxedo Touch User Manual

Remove All Z-Wave Devices

ICON
1. At the Tuxedo Touch Keypad:
a) Press the Automation icon from the
"Home" screen and then press the Z-
Wave Setup icon to display the "Z-
Wave Device Management" screen.
b) Press the Z-Wave Reset icon to delete
all devices from the controller.
c) Press Yes or No.

Abort a Z-Wave Action

ICON
1. From the "Home" screen, press the
Automation icon and the Z-Wave Setup icon.
The "Z-Wave Device Management" screen is
displayed.
2. If inadvertently a wrong selection was made,
(add, delete, or remove failed device) user
can press the Abort icon to abort the process.

Create a Scene

The "Scene" feature is used to control the function of a single device, or multiple devices based on pre-set Conditions, Triggers,
and Actions. When the trigger/condition occurs, the action is executed. View the "Customizable Automation Scene" training video
and then do the following:
ICON
1. At the Tuxedo Touch Keypad:
a) Press the Automation icon and then
press the Scene Setup icon to display
the "Scene Setup" screen.
b) Press the Add icon to set up a Scene.
c) Press the Name box, enter a Scene
Name and press OK.
d) Select a "Condition," "Trigger," and
"Action" that you want to occur for this
Scene. See example below.
After each selection press Save!! !
Automation (cont'd)
ACTION
The message is displayed:
ACTION
ACTION
• Press the ABC/.?123 key to switch between numerals and
38
NOTES
Window Warning
This Z-WAVE controller is about to be factory
defaulted and will lose all devices in the enrolled
list. All Z-WAVE devices must be re-enrolled
after this reset.
Yes or No
NOTES
NOTES
INFORMATION: Scenes must have at least a trigger and 1 action to work.
Enter the event to trigger the scene in the Trigger section. The Condition
section is optional.
Use the Data Entry Keyboard to enter all required information.
• Press the Up Arrow key to switch to capital letters
• Press the X key to delete
symbols/characters.
Press GO to return to the "Add New Camera" screen.
After each selection is complete, press Save to keep the settings.
Press Delete to cancel, or Edit to change your selections.
Press the Log icon to view a list of Scenes.