Mounting the Sliding Table Fence Assembly...
Introduce the Clamping Handle through its clamping washer and the arc slot into the tapped
hole in the sliding table. Pinch up the Clamping handle. Mount the distance stop by
introducing the dog into the wide channel in the top of the fence extrusion. Fit the
workpiece hold down clamp onto the main tool post and pinch up the clamping knob.
Sliding table
x2 Caphead
bolts
Mitre angle
rear quadrant
Distance stop
clamping knob
Telescopic
extension
Locate the two hand wheels. Fit the hand wheels onto the shafts for the tilt mechanism drive
and the rise and fall mechanism.
Note: the square key slots on the shafts, align the holding grubscrews with these slots.
Tighten securely. Check their security by raising and lowering and tilting the saw blade.
NOTE. Please ensure that the rise and fall LOCK is loosened before operating the
mechanism.
Tool post
Fitting the Hand Wheels...
FREEPHONE
Fig 18
Fig 19
0800 371822
W
A X M I N S T E R
W H I T E
Workpiece
hold down
clamp
assembly
Table fence
Clamping
knob
Clamping
handle
Distance stop
Telescopic
section
clamping
knob
19